Installation Instructions
CE-8010-08 Stator
The CE-8010-08 is a replacement stator for 2008 and later Dyna & Softial models. These are generalized instructions and are not intended to be all-inclusive. For more detail see a service manual on your model.
Stator Removal
1) Disconnect negative
battery terminal.
2) Drain primary case oil.
3) Remove outer primary
cover.
4) Consult appropriate
service manual and remove compensator sprocket.
.
6) Remove the
rotor.
7)
Unplug the regulator from the stator.
8) Remove the 4 stator-mounting screws.
From the out side of the
case, push the
protruding lip of the stator wire grommet into the engine case using a small
flat blade screw diver. Pull the wires through the case while removing the stator.
Stator Installation
1) Feed the stator wire
through the case. Aligned the posts on the base of the sealing grommet to be
parallel with the case. Pull the grommet through the case until the first lip
protrudes.
2) Mount the stator to the
engine case with new mounting screws supplied. Screws have thread-locking
compound already applied. Torque screws to 50-70 in-lbs.
3) Connect the stator plug to
the regulator. Install retaining clip.
! CAUTION!
When installing the rotor, keep fingers away from
edge. The magnetic force may cause rotor to suddenly be drawn inward and could
pinch fingers if in the way.
5) Install rotor slowly. Take
care not to let the magnets hit the stator. Do not let the rotor snap in to
place or magnet damage may occur.
6) Install outer primary and
other parts removed.
7) Add oil to primary case.
Have A Good Ride!!
For complete product listing
and technical information see our web site.
Rev. 3-10